Stepper Motor: Unipolar/Bipolar, 200 Steps/Rev, 42×48mm, 4V, 1.2 A/Phase

Stepper Motor: Unipolar/Bipolar, 200 Steps/Rev, 42×48mm, 4V, 1.2 A/Phase

CHF20.84

This NEMA 17-size hybrid stepping motor can be used as a unipolar or bipolar stepper motor and has a 1.8° step angle (200 steps/revolution). Each phase draws 1.2 A at 4 V, allowing for a holding torque of 3.2 kg-cm (44 oz-in).

Quantity
In Stock

This hybrid stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1.2 A at 4 V, allowing for a holding torque of 3.2 kg-cm (44 oz-in). The motor has six color-coded wires terminated with bare leads that allow it to be controlled by both unipolar and bipolar stepper motor drivers. When used with a unipolar stepper motor driver, all six leads are used. When used with a bipolar stepper motor driver, the center-tap yellow and white wires can be left disconnected (the red-blue pair gives access to one coil and the black-green pair gives access to the other coil). We recommend using it as a bipolar stepper motor and controlling it with one of our bipolar stepper motor drivers or one of our Tic Stepper Motor Controllers. In particular, the Tics make control easy because they support six different interfaces (USB, TTL serial, I²C, RC, analog voltages, and quadrature encoder) and are configurable over USB with our free configuration utility.

Our 5 mm universal mounting hub can be used to mount objects on the stepper motor’s 5 mm-diameter output shaft, and our NEMA 17 aluminum bracket offers a variety of options for mounting this stepper motor in your project.

Specifications:

  • Size: 42.3 mm square × 48 mm, not including the shaft (NEMA 17)
  • Weight: 350 g (13 oz)
  • Shaft diameter: 5 mm “D”
  • Steps per revolution: 200
  • Current rating: 1.2 A per coil
  • Voltage rating: 4 V
  • Resistance: 3.3 Ω per coil
  • Holding torque: 3.2 kg-cm (44 oz-in)
  • Inductance: 2.8 mH per coil
  • Lead length: 30 cm (12″)
  • Output shaft supported by two ball bearings

Dimensions:

Size: 42.3 mm square × 48 mm
(NEMA 17)
NEMA size: 17
Weight: 350 g
Shaft diameter: 5 mm

General specifications:

Shaft type: 5 mm "D"
Current rating: 1200 mA
Voltage rating: 4 V
Holding torque: 44 oz·in
Steps per revolution: 200
Resistance: 3.3 Ohm
Inductance per phase: 2.8 mH
Number of leads: 6
Lead length: 30 cm
PO-1200

Specific References

You might also like