• New
Gearmotor and Encoder Assembly for Romi/TI-RSLK MAX

Gearmotor and Encoder Assembly for Romi/TI-RSLK MAX

CHF12.77

This replacement gearmotor for the Romi/TI-RSLK MAX has an encoder already installed. The assembly is ready to plug into corresponding headers on our various Romi electronics modules, including the Romi 32U4 control board and the Romi Motor Driver and Power Distribution Board. Two of these are included with the Pololu Chassis Kit for TI-RSLK MAX.

Quantity
Backorder

The encoder has 0.1″-pitch (2.54 mm) male headers already soldered that allow it to plug into corresponding female headers on our various Romi electronics modules, including the Romi 32U4 control board and the Romi Motor Driver and Power Distribution Board.

Dimensions:

Weight: 21 g

General specifications:

Shaft type: offset 3mm D
Gear ratio: 120:1
No-load speed @ 4.5V: 150 rpm
No-load current @ 4.5V: 130 mA
Stall current @ 4.5V: 1250 mA
Stall torque @ 4.5V: 25 oz·in
PO-3675

Specific References

You might also like

5 other products in the same category: