120:1 Plastic Gearmotor, 90° Output

120:1 Plastic Gearmotor, 90° Output

CHF6.45

This 120:1 gearbox with brushed DC motor has a low-current motor and provides power and speed that is comparable to an RC servo at a fraction of the cost. It has a recommended operating voltage range of 3 V to 12 V.

Quantity
In Stock

This 120:1 plastic gearmotor (gearbox with brushed DC motor) is a great low-cost alternative to modified hobby servos or Tamiya gearboxes. The low-current motor is a perfect match for Pololu's qik 2s9v1 dual serial motor controller, Baby Orangutan robot controller, or DRV8833 dual motor driver carrier, and the compact size makes this unit an attractive choice for small robot designs. The recommended operating voltage range for this motor is 3 V to 12 V.

This is a lower-torque, higher-speed version of the 200:1 plastic gearmotor 90-degree output. At 6 V, the gearbox and motor provide approximately 75 oz-in of torque and 85 RPM. The free-running current is 70 mA, and the stall current is 800 mA. The gearbox is protected by a built-in safety clutch that will typically slip before gear teeth can shear.

This gearmotor comes pre-assembled, with the gears fully enclosed, and the output shaft is 6 mm long and 7 mm in diameter with two sides flattened. The output shaft is at a 90° angle from the axis of the motor shaft; we also sell a version of this gearmotor with an offset output shaft.

Dimensions:

Size: 64.4 x 22.3 x 21 mm
Weight: 32 g
Shaft diameter: 7 mm

General specifications:

Typical operating voltage: 6 V
Gear ratio: 120:1
No-load speed @ 6V: 85 rpm
No-load current @ 6V: 70 mA
Stall current @ 6V: 800 mA
Stall torque @ 6V: 75 oz·in

PO-1121

Specific References

You might also like

16 other products in the same category: