378:1 Metal Gearmotor 25Dx58L mm LP 12V

378:1 Metal Gearmotor 25Dx58L mm LP 12V

CHF20.38

This gearmotor consists of a low-power, 12 V brushed DC motor combined with a 377.93:1 metal spur gearbox. The gearmotor is cylindrical, with a diameter just under 25 mm, and the D-shaped output shaft is 4 mm in diameter and extends 12.5 mm from the face plate of the gearbox.

Quantity
In Stock

These cylindrical brushed DC gearmotors are available in a wide range of gear ratios and with five different motors (two power levels of 6 V motors and three power levels of 12 V motors). The gearmotors all have the same 25 mm diameter case and 4 mm diameter gearbox output shaft, so it is generally easy to swap one version for another if your design requirements change (though the length of the gearbox tends to increase with the gear ratio).

In general, these kinds of motors can run at voltages above and below their nominal voltages (they can begin rotating at voltages as low as 1 V); lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.

The face plate has two mounting holes threaded for M3 screws. You can use our custom-designed 25D mm metal gearmotor bracket (shown in the picture below) to mount the gearmotor to your project via these mounting holes and the screws that come with the bracket.

Dimensions

Size: 25D x 58L mm
Weight: 96 g
Shaft diameter: 4 mm

General specifications

Gear ratio: 377.93:1
No-load speed @ 12V: 14 rpm
No-load current @ 12V: 100 mA
Stall current @ 12V: 1100 mA
Stall torque @ 12V: 320 oz·in
No-load speed @ 6V: 7 rpm
Stall current @ 6V: 550 mA
Stall torque @ 6V: 160 oz·in
Motor type: 1.1A stall @ 12V (LP 12V)
Encoders?: N
PO-3258

Specific References

16 other products in the same category: