List of products by brand Sparkfun

Sparkfun

Sparkfun

  • CHF9.24

    A simple solder cup DB25 connector. Use this on PCBs as an edge mount connector for parallel port devices (programmers, stepper motor drivers, etc).

  • CHF2.09

    Simple shrouded 10-pin connector. Good for preventing cable connection mishaps. Use for programming, data, power, or any other kind of connection. 2x5 pins on 0.1" centers.

  • CHF18.52

    Magnet mount antenna for GPS modules operating at 3V.

    Designed for used with automobiles - the magnet will hold the antenna in place at speeds greater than 100mph.

    5meter cable terminated with MCX connector.

  • CHF2.74

    This is a handy AVR programming cable that incorporates both the 10-pin and 6-pin ISP programming interfaces.

    Cable is about 12" long and mates with pins on 1/10in centers.

  • CHF18.52

    The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The VCC pins of this FTDI cable are configured to operate at 5V with 3.3V I/O.

  • CHF13.88

    Magnet mount antenna for GPS modules operating at 3V.

    Designed for use with automobiles - the magnet will hold the antenna in place at speeds greater than 100mph.

    5 meter cable terminated with standard male SMA connector.

  • CHF16.02

    This is a three axis accelerometer for the LilyPad system. Based on the ADXL335 MEMS accelerometer from Analog Devices, the LilyPad Accelerometer can detect joint movement as well as inclination and vibration.

  • CHF23.17

    This is the LilyPad Arduino Simple Board. It's controlled by an ATmega328 with the Arduino bootloader. It has fewer pins than the LilyPad Arduino Main Board, a built in power supply socket, and an on/off switch. Any of our LiPo batteries can be plugged right into the socket.

  • CHF6.45

    The LilyPad SimpleSnap Protoboard is a new, easy way to create e-textiles projects with LilyPad that are modular and can be disassembled or broken down, it's also a great way to prototype!

    The SimpleSnap Protoboard is made to connect to the SimpleSnap main board so that the board is removable from your project for washing or so that multiple projects can share a board!

  • CHF5.99

    The LilyTiny is a tiny little LilyPad board designed to add flashy functionality to your project without taking up a lot of room. Even though it's as small as some of the LilyPad sensors, this board actually has an ATtiny microcontroller on it so it's actually pretty smart!

  • CHF1.62

    Screw Terminals with 5mm pitch pins. Comes in 2 or 3 positions and have the really cool feature of slide-locking together to form any size you need (4, 5, up to 20 without problems).

  • CHF18.52

    The Arduino Mega now has its very own prototyping shield! The SparkFun MegaShield mates with the Arduino Mega board and gives the user a prototyping area, two general LEDs, and, most important of all, the Arduino Mega reset switch is brought to the top level. The shield also works with our small breadboards if you don't want to solder to the prototyping area.