Accessories

Accessories

Accessories

Active filters

  • CHF10.17

    This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 36 V and efficiently reduces it to 12 V.

    The board measures only 0.7″ × 0.7″ yet delivers typical continuous output currents between 1.4 A and 2.2 A, depending on the input voltage, which makes this regulator well suited for powering moderate loads like sensors or small motors.

    An optional enable input can be used to put the regulator in a low-power state with a current draw of 5 µA to 10 µA per volt on VIN.

    The regulator also features reverse voltage protection and a power-good output indicates when the regulator cannot adequately maintain the output voltage.

  • CHF2.55

    This single-pole, double-throw (SPDT) momentary switch can be used as a general-purpose micro switch or tactile bump sensor for your robot. The switch body dimension is 20.0 x 6.4 x 10.2 mm, and the 15.6mm lever arm has a semicircular bump at the tip that simulates a roller.

  • CHF13.88

    Aluminium Heatsink Case for Raspberry Pi 4

  • CHF41.74

    This synchronous switching step-down (or buck) regulator takes an input voltage of up to 40 V and efficiently reduces it to 9 V with an available output current of around 15 A. Typical efficiencies of 80% to 95% along with its high current capabilities make this regulator well suited for powering large loads. The regulator features reverse voltage protection and a power-good output that indicates when the regulator cannot adequately maintain the output voltage.

  • CHF2.74

    This single-pole, double-throw (SPDT) momentary switch can be used as a general-purpose micro switch or tactile bump sensor for your robot. The switch body dimension is 20.0 x 6.4 x 10.2 mm, and the 16.3mm lever arm is has a roller at the tip.

  • CHF9.24

    Raspberry Pi Official USB-C Power Supply

  • CHF9.24

    A simple solder cup DB25 connector. Use this on PCBs as an edge mount connector for parallel port devices (programmers, stepper motor drivers, etc).

  • CHF2.55

    This single-pole, double-throw (SPDT) momentary switch can be used as a general-purpose micro switch or tactile bump sensor for your robot. The switch body dimension is 20.0 x 6.4 x 10.2 mm, and the lever arm is 16.7 mm long.

  • CHF41.74

    This synchronous switching step-down (or buck) regulator takes an input voltage of up to 40 V and efficiently reduces it to 3.3 V with an available output current of around 15 A. Typical efficiencies of 80% to 95% along with its high current capabilities make this regulator well suited for powering large loads. The regulator features reverse voltage protection and a power-good output that indicates when the regulator cannot adequately maintain the output voltage.